Cutek Wood Stripper 4L

Cutek Woodstripper previously known as CD50 Naked Stripper Paint and Stain Remover 4L

Effectively removes most surface coatings from timber, metal, brick and masonry surfaces.

Cutek Wood Stripper is a safe alternative to using dangerous Methylene Chloride strippers. It has very little odour and if it contacts the skin, there is plenty of time to wash it off before burning occurs. Of course, eye and skin protection is recommended.

Application

Apply CUTEK® Wood Stripper evenly with a brush, roller or lambswool applicator to dry wood, rubbing into the grain. Reaction time is approx. 30-60 minutes. Keep area wet and activated by applying more CUTEK® Wood Stripper or by agitating the application area with a brush, roller or lambswool applicator. CUTEK® Wood Stripper makes surfaces slippery so DO NOT walk on the application area until CUTEK® Wood Stripper has been removed.

Test periodically with a paint scraper to determine when the old coat is stripping cleanly off the timber. When this happens, the stripped surface is ready for rinsing. We suggest that you try to strip only 1 square metre first to perfect your technique.

Removal

Once CUTEK® Wood Stripper has loosened the coating, it must be power rinsed off thoroughly. For best results, power rinse with a high-pressure washer set to
approximately 50 bar (750 p.s.i.) with a fan jet pattern. REMOVAL WITH A GARDEN HOSE IS NOT SUFFICIENT.

CAUTION must be used when cleaning soft timber. Reduce the pressure or adjust distance from the substrate to avoid damaging the sapwood. It is important to adjust your cleaning process as to avoid damage to the wood fibre.

Clean from the lowest point and work upwards methodically using long even strokes in the direction of the grain. DO NOT use “turbojets” on timber.

Certain types of wood surfaces may leave a raised grain effect after stripping is completed. Sanding or poly pad scrubbing may be required to smooth out this
condition.

After stripping the timber, clean your wood with CUTEK® Restore to remove residual CUTEK® Wood Stripper and rejuvenate the substrate and enhance the grain. See CUTEK® Restore for instructions.

Clean Up 

Equipment may be cleaned with CUTEK® Quickclean or soap/detergent and water.

Coverage is approximately 3sqm per litre, but this can vary widely.